Skylight installation is a roofing job, not a window job. It requires cutting through your roof deck sheathing, framing a structural curb between the trusses or rafters, and building a weatherproof barrier with flashing, underlayment, and sealant. Thompsons Roofing & Maintenance has been installing skylights in Thompsons for 19 years — every one leak-free.
We install deck-mounted skylights and curb-mounted skylights. Deck-mounted units sit flush against the roof deck and work best for shingle roofs on standard pitch. Curb-mounted units sit on a raised frame and work on flat or low-slope roofs. Both types get the same flashing treatment: ice-and-water shield, step flashing, counter-flashing, and sealant at every transition.
Our Skylight Installation Process
Skylight Planning
We assess your roof from above and inside the attic. We locate the trusses and rafters, check the roof deck sheathing condition, and identify the best skylight placement for natural light based on sun angle, room layout, and roof pitch.
Roof Opening & Framing
Precise opening cut through the roof deck. Structural curb framed between trusses with load-bearing headers. Every cut edge of the sheathing sealed. The curb is the structural foundation — we don't skimp on the framing.
Seal Integration
Ice-and-water shield wrapped around the entire curb perimeter. Step flashing installed on all four sides, woven into the shingle courses. Counter-flashing at the top integrates with the shingles above. Sealant at every transition point. This flashing system is what prevents leaks — it's the most critical step.
Final Seal & Trim
Unit installed and sealed. Light shaft insulated and trimmed. We verify the seal from inside the attic — if we can see any daylight at the flashing joints, we re-seal before we leave. Your skylight is watertight and energy-efficient.
What Thompsons Customers Say
"Best experience we've ever had with a home service company. On time, on budget, and the results exceeded what we expected. Truly top-notch."
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
"Responded fast and got the job done right the first time. Crew was polite, professional, and cleaned up everything. Would absolutely hire again."
Why Choose Thompsons Roofing & Maintenance for Skylight Installation?
Code Compliant
Every skylight installation meets TX building code for structural framing, energy performance, and egress requirements. Permits pulled when required.
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.
Leak-Free Guarantee
Every skylight gets ice-and-water shield, step flashing on all four sides, counter-flashing, and sealant at every transition. Verified from inside the attic before we leave. If it leaks, we fix it free.